flexiblefullpage -
billboard - default
interstitial1 - interstitial
catfish1 - bottom
Currently Reading

Study analyzes effectiveness of reflective ceilings

Study analyzes effectiveness of reflective ceilings

Engineers at Brinjac quantify the illuminance and energy consumption levels achieved by increasing the ceiling’s light reflectance.


By C.C. Sullivan and Barbara Horwitz-Bennett | September 16, 2013
To quantify the illuminance and energy consumption levels achieved by increasing the ceiling’s light reflectance (LR), ceiling system manufacturer Armstrong World Industries commissioned Brinjac Engineering to conduct two controlled studies. (Illuminance is a measure of the intensity of light on a unit area of a surface.)
 
In the first study, four different room configurations were outfitted with a direct recessed 2X2-foot parabolic troffer and an indirect pendant. One set of rooms was given a 75% reflective ceiling; the others, a 90% reflective ceiling. After measuring work plane illuminance in both sets of rooms, Brinjac found the 0.90 LR ceiling to increase direct lighting levels by just 2–5%; however, indirect lighting levels jumped by almost 22% and offered greater lighting uniformity.
 
Although work plane illuminance from direct lighting only increased modestly when changing the light reflectance from 0.75 to 0.90, the effect of indirect lighting on work plane illuminance was significant. In addition, the higher LR value enabled a reduction in indirect luminaire fixtures and a decrease in lighting power density.
 
Based on these results, specifiers can use fewer fixtures or lower wattage levels to achieve required lighting levels, which can reduce energy costs, as analyzed in the second study where the 90% reflective ceiling tile was installed in the same spaces with an optimized lighting design and compared to the 75% and 90% ceiling with the original lighting scheme.
 
After comparing the three ceiling designs, the Brinjac researchers found that:
• Spacing between indirect luminaire sections with the 0.90 ceiling could be increased, thereby reducing the total number of luminaires required to achieve light levels afforded by the 0.75 ceiling.
• The 0.90 reflective ceiling with indirect fixtures yielded a 23% lower lighting power density than the 0.75 ceiling, and 21% lower than the parabolic troffer layout.
• This lighting power density reduction was calculated to achieve 9% HVAC energy costs savings, as compared to the 0.75 ceiling, and 7% in relation to the troffer layout.
 
For more information on this study, see: http://www.armstrong.com/common/c2002/content/files/38652.pdf. 

Related Stories

| Mar 13, 2012

Commercial glazer Harmon expanding into Texas

Company expanding into the Texas market with a new office in Dallas and a satellite facility in Austin.

| Mar 6, 2012

EwingCole completes first design-build project for the USMA

The second phase of the project, which includes the academic buildings and the lacrosse and football fields, was completed in January 2012.

| Mar 5, 2012

Franklin Institute in Philadelphia selects Skanska to construct new pavilion

The building has been designed by SaylorGregg Architects and will apply for LEED Silver certification.

| Mar 1, 2012

AIA: A clear difference, new developments in load-bearing glass

Earn 1.0 AIA/CES learning units by studying this article and successfully completing the online exam.

| Mar 1, 2012

Reconstruction Awards: Reinvesting in a neighborhood’s future

The reconstruction of a near-century-old derelict public works facility in Minneapolis earns LEED Platinum—and the hearts and minds of the neighboring community.

| Feb 29, 2012

C.W. Driver opens new office, appoints Castillo regional SVP

Castillo will oversee projects with new and existing clients in northern California within the areas of education, healthcare/biomedical, public sector, military contracting, entertainment, retail, corporate and hospitality.

| Feb 29, 2012

Report says BIPV glass market to reach $6.4 billion by 2016

The report analyzes the opportunities for BIPV glass products using c-Si, thin-film and OPV/DSC materials and provides eight-year forecasts in terms of MW and square footage shipped as well as forecasts of revenue generated.

| Feb 28, 2012

Griffin Electric completes Medical University of South Carolina project

The 210,000-sf complex is comprised of two buildings, and houses research, teaching and office areas, plus conference spaces for the University.

| Feb 27, 2012

Consigli complete first building for Bigelow Ocean Sciences Campus

Designed by WBRC Architects Engineers in association with Perkins + Will.

| Feb 22, 2012

Siemens earns LEED certification for Maryland office

The Beltsville facility, which also earned the ENERGY STAR Label for energy performance, implemented a range of energy efficiency, water conservation and sustainable operations measures as part of the certification process.

boombox1 - default
boombox2 -
native1 -

More In Category

AEC Tech

Lack of organizational readiness is biggest hurdle to artificial intelligence adoption

Managers of companies in the industrial sector, including construction, have bought the hype of artificial intelligence (AI) as a transformative technology, but their organizations are not ready to realize its promise, according to research from IFS, a global cloud enterprise software company. An IFS survey of 1,700 senior decision-makers found that 84% of executives anticipate massive organizational benefits from AI. 




halfpage1 -

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021