flexiblefullpage -
billboard - default
interstitial1 - interstitial
catfish1 - bottom
Currently Reading

Study analyzes effectiveness of reflective ceilings

Study analyzes effectiveness of reflective ceilings

Engineers at Brinjac quantify the illuminance and energy consumption levels achieved by increasing the ceiling’s light reflectance.


By C.C. Sullivan and Barbara Horwitz-Bennett | September 16, 2013
To quantify the illuminance and energy consumption levels achieved by increasing the ceiling’s light reflectance (LR), ceiling system manufacturer Armstrong World Industries commissioned Brinjac Engineering to conduct two controlled studies. (Illuminance is a measure of the intensity of light on a unit area of a surface.)
 
In the first study, four different room configurations were outfitted with a direct recessed 2X2-foot parabolic troffer and an indirect pendant. One set of rooms was given a 75% reflective ceiling; the others, a 90% reflective ceiling. After measuring work plane illuminance in both sets of rooms, Brinjac found the 0.90 LR ceiling to increase direct lighting levels by just 2–5%; however, indirect lighting levels jumped by almost 22% and offered greater lighting uniformity.
 
Although work plane illuminance from direct lighting only increased modestly when changing the light reflectance from 0.75 to 0.90, the effect of indirect lighting on work plane illuminance was significant. In addition, the higher LR value enabled a reduction in indirect luminaire fixtures and a decrease in lighting power density.
 
Based on these results, specifiers can use fewer fixtures or lower wattage levels to achieve required lighting levels, which can reduce energy costs, as analyzed in the second study where the 90% reflective ceiling tile was installed in the same spaces with an optimized lighting design and compared to the 75% and 90% ceiling with the original lighting scheme.
 
After comparing the three ceiling designs, the Brinjac researchers found that:
• Spacing between indirect luminaire sections with the 0.90 ceiling could be increased, thereby reducing the total number of luminaires required to achieve light levels afforded by the 0.75 ceiling.
• The 0.90 reflective ceiling with indirect fixtures yielded a 23% lower lighting power density than the 0.75 ceiling, and 21% lower than the parabolic troffer layout.
• This lighting power density reduction was calculated to achieve 9% HVAC energy costs savings, as compared to the 0.75 ceiling, and 7% in relation to the troffer layout.
 
For more information on this study, see: http://www.armstrong.com/common/c2002/content/files/38652.pdf. 

Related Stories

| Feb 22, 2012

CISCO recognizes Gilbane for quality construction, design, and safety

The project employed more than 2,000 tradespeople for a total of 2.1 million hours worked – all without a single lost-time accident. 

| Feb 17, 2012

Tremco Inc. headquarters achieves LEED Gold certification

Changes were so extensive that the certification is for new construction and not for renovation; officially, the building is LEED-NC.

| Feb 15, 2012

Code allowance offers retailers and commercial building owners increased energy savings and reduced construction costs

Specifying air curtains as energy-saving, cost-cutting alternatives to vestibules in 3,000-square-foot buildings and larger has been a recent trend among consulting engineers and architects.

| Feb 13, 2012

WHR Architects renovation of Morristown Memorial Hospital Simon Level 5 awarded LEED Gold

Located in the Simon Building, which serves as the main entrance leading into the Morristown Memorial Hospital campus, the project comprises three patient room wings connected by a centralized nursing station and elevator lobby.

| Feb 8, 2012

World’s tallest solar PV-installation

The solar array is at the elevation of 737 feet, making the building the tallest in the world with a solar PV-installation on its roof.

| Feb 6, 2012

Siemens gifts Worcester Polytechnic Institute $100,000 for fire protection lab renovation

Siemens support is earmarked for the school’s Fire Protection Engineering Lab, a facility that has been forwarding engineering and other advanced degrees, graduating fire protection engineers since 1979.

| Feb 2, 2012

Call for Entries: 2012 Building Team Awards. Deadline March 2, 2012

Winning projects will be featured in the May issue of BD+C. 

| Feb 1, 2012

‘Augmented reality’ comes to the job site

A new software tool derived from virtual reality is helping Building Teams use the power of BIM models more effectively.

| Feb 1, 2012

Blackney Hayes designs school for students with learning differences

The 63,500 sf building allows AIM to consolidate its previous two locations under one roof, with room to expand in the future. 

| Jan 31, 2012

Fusion Facilities: 8 reasons to consolidate multiple functions under one roof

‘Fusing’ multiple functions into a single building can make it greater than the sum of its parts. The first in a series  on the design and construction of university facilities.

boombox1 - default
boombox2 -
native1 -

More In Category

AEC Tech

Lack of organizational readiness is biggest hurdle to artificial intelligence adoption

Managers of companies in the industrial sector, including construction, have bought the hype of artificial intelligence (AI) as a transformative technology, but their organizations are not ready to realize its promise, according to research from IFS, a global cloud enterprise software company. An IFS survey of 1,700 senior decision-makers found that 84% of executives anticipate massive organizational benefits from AI. 




halfpage1 -

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021