flexiblefullpage -
billboard - default
interstitial1 - interstitial
catfish1 - bottom
Currently Reading

Study analyzes effectiveness of reflective ceilings

Study analyzes effectiveness of reflective ceilings

Engineers at Brinjac quantify the illuminance and energy consumption levels achieved by increasing the ceiling’s light reflectance.


By C.C. Sullivan and Barbara Horwitz-Bennett | September 16, 2013
To quantify the illuminance and energy consumption levels achieved by increasing the ceiling’s light reflectance (LR), ceiling system manufacturer Armstrong World Industries commissioned Brinjac Engineering to conduct two controlled studies. (Illuminance is a measure of the intensity of light on a unit area of a surface.)
 
In the first study, four different room configurations were outfitted with a direct recessed 2X2-foot parabolic troffer and an indirect pendant. One set of rooms was given a 75% reflective ceiling; the others, a 90% reflective ceiling. After measuring work plane illuminance in both sets of rooms, Brinjac found the 0.90 LR ceiling to increase direct lighting levels by just 2–5%; however, indirect lighting levels jumped by almost 22% and offered greater lighting uniformity.
 
Although work plane illuminance from direct lighting only increased modestly when changing the light reflectance from 0.75 to 0.90, the effect of indirect lighting on work plane illuminance was significant. In addition, the higher LR value enabled a reduction in indirect luminaire fixtures and a decrease in lighting power density.
 
Based on these results, specifiers can use fewer fixtures or lower wattage levels to achieve required lighting levels, which can reduce energy costs, as analyzed in the second study where the 90% reflective ceiling tile was installed in the same spaces with an optimized lighting design and compared to the 75% and 90% ceiling with the original lighting scheme.
 
After comparing the three ceiling designs, the Brinjac researchers found that:
• Spacing between indirect luminaire sections with the 0.90 ceiling could be increased, thereby reducing the total number of luminaires required to achieve light levels afforded by the 0.75 ceiling.
• The 0.90 reflective ceiling with indirect fixtures yielded a 23% lower lighting power density than the 0.75 ceiling, and 21% lower than the parabolic troffer layout.
• This lighting power density reduction was calculated to achieve 9% HVAC energy costs savings, as compared to the 0.75 ceiling, and 7% in relation to the troffer layout.
 
For more information on this study, see: http://www.armstrong.com/common/c2002/content/files/38652.pdf. 

Related Stories

| Jun 12, 2012

BCA Architects transforms Anaheim schools into dynamic learning environments

BCA Architects was selected to update the district's long-range master plan.

| Jun 11, 2012

Hill International selected as CM for Porto Arabia Towers in Qatar

The complex is a mixed-use development featuring both residential and commercial properties.

| Jun 8, 2012

Living Building Challenge wins the 2012 Buckminster Fuller Challenge

The Living Building Challenge was chosen from a pool of 122 of entries from around the world.

| Jun 8, 2012

Nauset Construction completing sustainable dorm for Brooks School

Student input on green elements provides learning experience.

| Jun 8, 2012

Skyline Construction names Millitello president

Millitello is a 31-year veteran who has overseen the construction of campus-size projects.

| Jun 1, 2012

New BD+C University Course on Insulated Metal Panels available

By completing this course, you earn 1.0 HSW/SD AIA Learning Units.

| Jun 1, 2012

Ground broken for Children’s Hospital Colorado South Campus

Children’s Hospital Colorado expects to host nearly 80,000 patient visits at the South Campus during its first year.

| Jun 1, 2012

K-State Olathe Innovation Campus receives LEED Silver

Aspects of the design included a curtain wall and punched openings allowing natural light deep into the building, regional materials were used, which minimized the need for heavy hauling, and much of the final material included pre and post-consumer recycled content.

| Jun 1, 2012

New York City Department of Buildings approves 3D BIM site safety plans

3D BIM site safety plans enable building inspectors to take virtual tours of construction projects and review them in real-time on site.

| May 31, 2012

3 Metal Roofing Case Studies Illustrate Benefits

Metal roofing systems offer values such as longevity, favorable life cycle costs, and heightened aesthetic appeal.

boombox1 - default
boombox2 -
native1 -

More In Category




halfpage1 -

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021