flexiblefullpage -
billboard - default
interstitial1 - interstitial
catfish1 - bottom
Currently Reading

Steps to improve ventilation for Covid can combat colds and flu

Codes and Standards

Steps to improve ventilation for Covid can combat colds and flu

New look at airborne disease spread shows time viruses linger in air may have been underestimated.


By Peter Fabris, Contributing Editor | September 21, 2021
Ceiling ventilation

Courtesy Pixabay

The way viruses spread from human to human is being reevaluated by scientists and that may have an impact on future ventilation standards.

At the outset of the Covid-19 outbreak, the prevailing belief was that the virus was spread via droplets that quickly dropped out of the air. As researchers studied the virus, however, they realized that it was likely spread via aerosols—smaller, lighter particles that travel further than six feet and can linger in the air in poorly ventilated spaces.

Colds and flu have been thought to be primarily spread via droplets, as well, as they hold more viruses than aerosols. But studies have found that a smaller amount of influenza virus is needed to infect people when inhaled as aerosols rather than sprayed up the nose as saliva droplets.

If this view is correct, improved ventilation could greatly reduce transmission of colds and flu viruses as well as Covid. For this reason, some believe new minimum ventilation standards in buildings should be enacted especially when one considers some 12,000 to 61,000 people annually succumb to the flu.

Related Stories

| Sep 26, 2012

Investment in greener data centers to reach $45 billion by 2016

Investment in data centers built to green standards will increase from the $17.1 billion predicted for this year to $45 billion by 2016, according to Pike Research.

| Sep 26, 2012

OSHA fines on fall-protection violations challenged by New York contractor

A New York masonry contractor is contesting an OccupationalSafety and Health Administration $136,290 fine for violations of fall-protection standards.a

| Sep 26, 2012

Construction workplace deaths decline nearly 7% in 2011

There were 721 construction-workplace deaths in 2011, according to the Bureau of Labor Statistics, down 6.8% from 2010.

| Sep 26, 2012

Contractors save $9 billion due to revised California emissions rule

The California Air Resources Board made changes to a rule limiting off-road diesel emissions that could result in contractors saving about $9 billion.

| Sep 20, 2012

Smithtown, N.Y. considers bigger fines for building code violations

After a Suffolk County grand jury recommended stiffer fines for illegal demolitions, Smithtown, NY officials are weighing tougher penalties for developers who violate the town building code.

| Sep 20, 2012

AGC awarded federal grant to provide fall-protection safety program

The Associated General Contractors of America will continue to provide fall protection safety training next year after being awarded a federal safety grant.

| Sep 20, 2012

East Lansing officials accused of ignoring unauthorized project that led to partial building collapse

The unauthorized construction of a fifth-floor penthouse on a downtown East Lansing, Mich. mixed-use development led to a partial building collapse earlier this year.

| Sep 20, 2012

Reflective roofs could reduce rainfall in Arizona

Green standards may have to take into account the impact of reflective roofs on rainfall in the desert Southwest.

| Sep 20, 2012

Earth Advantage Institute offers green certification for small commercial buildings

Earth Advantage Institute announced a new green building certification aimed at new or substantially remodeled small commercial buildings built to green standards.

| Sep 14, 2012

To create more pedestrian-friendly neighborhoods, Chicago unveils safety plan

As more urban mixed-use and residential developments aim to encourage residents to walk and use mass transit, cities are addressing pedestrian safety.

boombox1 - default
boombox2 -
native1 -

More In Category


AEC Tech

Lack of organizational readiness is biggest hurdle to artificial intelligence adoption

Managers of companies in the industrial sector, including construction, have bought the hype of artificial intelligence (AI) as a transformative technology, but their organizations are not ready to realize its promise, according to research from IFS, a global cloud enterprise software company. An IFS survey of 1,700 senior decision-makers found that 84% of executives anticipate massive organizational benefits from AI. 


Codes and Standards

Updated document details methods of testing fenestration for exterior walls

The Fenestration and Glazing Industry Alliance (FGIA) updated a document serving a recommended practice for determining test methodology for laboratory and field testing of exterior wall systems. The document pertains to products covered by an AAMA standard such as curtain walls, storefronts, window walls, and sloped glazing. AAMA 501-24, Methods of Test for Exterior Walls was last updated in 2015. 


MFPRO+ News

World’s largest 3D printer could create entire neighborhoods

The University of Maine recently unveiled the world’s largest 3D printer said to be able to create entire neighborhoods. The machine is four times larger than a preceding model that was first tested in 2019. The older model was used to create a 600 sf single-family home made of recyclable wood fiber and bio-resin materials.

halfpage1 -

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021