Casting concrete beams in fabric formwork reduces concrete needed by two-thirds
Researchers at the Massachusetts Institute of Technology found that software-designed concrete beams casted in fabric formwork significantly reduces the amount of concrete needed compared to conventionally produced beams.
Beams cast in fabric formwork can require just one-third as much concrete and half as much steel reinforcement as beams produced by typical means to bear the same load, the researchers found. They used software to identify where concrete could be removed, producing a beam with narrow, angled legs connecting upper and lower sections.
The design was translated into flat fabric patterns, accounting for how the cotton would stretch and sag under the weight of wet concrete. Researchers sewed the pieces together and stapled the mold to a timber frame. During the pour, they worked the concrete through narrow sections by tapping and kneading the fabric.
Fabric formwork has been explored for years to create beams that vary in depth but has proven difficult to realize because fabric deforms under the weight of wet concrete. The researchers say this challenge can be overcome with the right computational pattern design.
The most promising applications for this casting method is in one-off or small-batch components, including exposed beams and pedestrian structures, where complex shapes can make rigid molds expensive to produce, researchers say.


