flexiblefullpage -
billboard - default
interstitial1 - interstitial
catfish1 - bottom
Currently Reading

Construction spending hits four-year peak after rare spike in public outlays

Construction spending hits four-year peak after rare spike in public outlays

Totals for the first 10 months of 2013 show a jump in residential construction, flat nonresidential work, and a drop in public categories.


By AGC | December 3, 2013

An unusual surge in public construction in October pushed total construction spending to its highest level since May 2009 despite a dip in both private residential and nonresidential activity, according to an analysis of new Census Bureau data by the Associated General Contractors of America. Association officials urged lawmakers in Washington to make water and surface transportation investment a top federal priority.

“Nearly every category of public construction increased in October, according to the preliminary Census figures, although for the first 10 months of 2013 combined, public spending continues to lag the 2012 year-to-date total,” said Ken Simonson, the association's chief economist. “Meanwhile, residential spending slipped for the month but still showed strong year-to-date gains, and nonresidential spending remained stuck in neutral.”

Construction put in place in October totaled $908 billion, 0.8 percent higher than in September. But figures for August and July were revised down below levels that initially exceeded the current October estimate. The total for the first 10 months of 2013 was 5.0 percent above the year-to-date mark for the same months in 2012.

Public construction spending jumped 3.9 percent for the month but trailed the 2012 year-to-date total by 2.8 percent. The two largest public components were mixed: highway and street construction increased 0.6 percent in October and 0.3 percent year-to-date, while educational construction leaped 8.5 percent for the month but fell 8.5 percent year-to-date, Simonson said.

Private residential spending slid 0.6 percent for the month but still climbed 17 percent year-to-date. New single-family construction decreased 0.6 percent in October but soared 30 percent in the first 10 months of 2013 compared with 2012. New multifamily spending advanced 2.2 percent in October and 46 percent year-to-date.

Private nonresidential spending edged down 0.5 percent for the month and up 0.8 percent year-to-date, Simonson observed. The largest private nonresidential category, power—including oil and gas as well as electricity—plunged 5.7 percent and 5.8 percent over the two time periods. But the next three niches in size—manufacturing, commercial (retail, warehouse and farm), and office—rose for the month and year-to-date.

“Construction will likely display varied patterns in the next several months,” Simonson said. “Multifamily construction will keep burgeoning but single-family homebuilding may stall. Private nonresidential spending should benefit from more power, energy and manufacturing work. Public construction remains threatened.”

Association officials said Congress and the administration should keep public construction from returning to its recent slump by quickly completing Water Resources Development legislation that has already passed both houses and passing a new surface transportation bill next year that funds repairs to deteriorating highway, bridge and transit infrastructure.  They added that any new transportation bill must include provisions to adequately fund the nearly depleted federal Highway Trust Fund.

“If Congress can act in a bipartisan way on transportation funding as it did on the Water Resources bill, it can avoid a cliff-like drop in highway spending,” said Stephen E. Sandherr, the association’s chief executive officer.

Related Stories

Affordable Housing | Apr 1, 2024

Chicago voters nix ‘mansion tax’ to fund efforts to reduce homelessness

Chicago voters in March rejected a proposed “mansion tax” that would have funded efforts to reduce homelessness in the city.

Standards | Apr 1, 2024

New technical bulletin covers window opening control devices

A new technical bulletin clarifies the definition of a window opening control device (WOCD) to promote greater understanding of the role of WOCDs and provide an understanding of a WOCD’s function.

Adaptive Reuse | Mar 30, 2024

Hotel vs. office: Different challenges in commercial to residential conversions

In the midst of a national housing shortage, developers are examining the viability of commercial to residential conversions as a solution to both problems.

Sustainability | Mar 29, 2024

Demystifying carbon offsets vs direct reductions

Chris Forney, Principal, Brightworks Sustainability, and Rob Atkinson, Senior Project Manager, IA Interior Architects, share the misconceptions about carbon offsets and identify opportunities for realizing a carbon-neutral building portfolio.

Reconstruction & Renovation | Mar 28, 2024

Longwood Gardens reimagines its horticulture experience with 17-acre conservatory

Longwood Gardens announced this week that Longwood Reimagined: A New Garden Experience, the most ambitious revitalization in a century of America’s greatest center for horticultural display, will open to the public on November 22, 2024.

Office Buildings | Mar 27, 2024

A new Singapore office campus inaugurates the Jurong Innovation District, a business park located in a tropical rainforest

Surbana Jurong, an urban, infrastructure and managed services consulting firm, recently opened its new headquarters in Singapore. Surbana Jurong Campus inaugurates the Jurong Innovation District, a business park set in a tropical rainforest.

Cultural Facilities | Mar 27, 2024

Kansas City’s new Sobela Ocean Aquarium home to nearly 8,000 animals in 34 habitats

Kansas City’s new Sobela Ocean Aquarium is a world-class facility home to nearly 8,000 animals in 34 habitats ranging from small tanks to a giant 400,000-gallon shark tank. 

Market Data | Mar 26, 2024

Architecture firm billings see modest easing in February

Architecture firm billings continued to decline in February, with an AIA/Deltek Architecture Billings Index (ABI) score of 49.5 for the month. However, February’s score marks the most modest easing in billings since July 2023 and suggests that the recent slowdown may be receding.

Cultural Facilities | Mar 26, 2024

Renovation restores century-old Brooklyn Paramount Theater to its original use

The renovation of the iconic Brooklyn Paramount Theater restored the building to its original purpose as a movie theater and music performance venue. Long Island University had acquired the venue in the 1960s and repurposed it as the school’s basketball court.

Adaptive Reuse | Mar 26, 2024

Adaptive Reuse Scorecard released to help developers assess project viability

Lamar Johnson Collaborative announced the debut of the firm’s Adaptive Reuse Scorecard, a proprietary methodology to quickly analyze the viability of converting buildings to other uses.

boombox1 - default
boombox2 -
native1 -

More In Category

AEC Tech

Lack of organizational readiness is biggest hurdle to artificial intelligence adoption

Managers of companies in the industrial sector, including construction, have bought the hype of artificial intelligence (AI) as a transformative technology, but their organizations are not ready to realize its promise, according to research from IFS, a global cloud enterprise software company. An IFS survey of 1,700 senior decision-makers found that 84% of executives anticipate massive organizational benefits from AI. 


Codes and Standards

Updated document details methods of testing fenestration for exterior walls

The Fenestration and Glazing Industry Alliance (FGIA) updated a document serving a recommended practice for determining test methodology for laboratory and field testing of exterior wall systems. The document pertains to products covered by an AAMA standard such as curtain walls, storefronts, window walls, and sloped glazing. AAMA 501-24, Methods of Test for Exterior Walls was last updated in 2015. 


MFPRO+ News

World’s largest 3D printer could create entire neighborhoods

The University of Maine recently unveiled the world’s largest 3D printer said to be able to create entire neighborhoods. The machine is four times larger than a preceding model that was first tested in 2019. The older model was used to create a 600 sf single-family home made of recyclable wood fiber and bio-resin materials.


halfpage1 -

Most Popular Content

  1. 2021 Giants 400 Report
  2. Top 150 Architecture Firms for 2019
  3. 13 projects that represent the future of affordable housing
  4. Sagrada Familia completion date pushed back due to coronavirus
  5. Top 160 Architecture Firms 2021